ArtLube™-100 Rapid Mold Release
Comparable to Synlube 531. ArtLube-100 is a silicone-based release agent specifically formulated for use with polyurethane molding systems and KastEZ urethane casting system It can also be used with other polyurethanes, epoxies, polyester resins, and silicone rubbers.
ARTLUBE-100 is a silicone-based release agent specifically formulated for use with ArtMolds' flexible urethane molding system Make-A-Mold and ArtMolds urethane casting system KastEZ resin. It can also be used with other polyurethanes, epoxies, polyester resins, and silicone rubbers. It is a liquid external release agent that dries at room temperature forming a monomolecular film which adheres by adsorption to the mold walls and has no affinity for the resin. This selective adhesion prevents the film from easily being torn off by the demolded part
Uses : Polyurethane – All Types.
Composition : A proprietary complex resin solution of cross-linked polyolefins in volatile hydrocarbon solvents.
Directions : ARTLUBE-100 is available in 16-ounce spray can (12 to a case), 1-Gallon containers, 5-Gallon Pails, and 55-Gallon Drums. It may be applied to hot or cold molds by spraying, wiping or brushing. Spraying with a fine mist is preferable because it eliminates wipe or brush marks and results in the smoothest finish with the fastest drying time. Allow the solvent to evaporate and the surface to dry for about 10-minutes. For quicker drying times, dry the master or mold surface with warm air. Use sparingly. Too much mold release will build up and could cover some mold details. All information given by us about our products is based upon our tests and experience. It is intended for use by persons having technical skill.
