Block Mold - Multi-Part | Page 5 - ArtMolds
![Block Mold Multi 29 Block Mold Multi 29](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/29m.jpg?v=1710991298)
Figure 29
Pour the material high, slowly and in a narrow stream, starting from the corner of the mold box, or mold, letting the material flow freely into the box or mold cavity. Because the pour is in a high narrow stream, trapped air can better escape from the downward stream of silicone rubber before it enters the mold box. This method will usually not introduce any new bubbles into the vacuumed material.
![Block Mold Multi 30 Block Mold Multi 30](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/30m.jpg?v=1710991299)
Figure 30
The mold box is removed after the silicone rubber has cured. It will feel firm to the touch without being tacky.
![Block Mold Multi 31 Block Mold Multi 31](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/31m.jpg?v=1710991302)
Figure 31
The two halves of the silicone mold are spread open to reveal the model.
![Block Mold Multi 32 Block Mold Multi 32](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/32m.jpg?v=1710991303)
Figure 32
At the bottom end of the mold a large pour hole is cut into the rubber using a mold knife or an Exacto knife
![Block Mold Multi 33 Block Mold Multi 33](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/33m.jpg?v=1710991305)
Figure 33
Figure 33 shows both mold halfs with a semicircular cut on the bottom of each. When the halves are joined together this will become a round opening so that the casting material may easily be poured to fill the mold.
Figure 34
Figure 34 shows a finishing technique. We will use KastEZ Resin for the casting material. By spraying the inside of the silicone mold with acrylic paint it will adhere to the surface of the cure casting creating a pre-made finish. In this example we use black acrylic paint to establish a dark undercoat which will help create a metallic look when the final finishes are applied to the casting.
![Block Mold Multi 35 Block Mold Multi 35](https://cdn.shopify.com/s/files/1/0688/2430/1785/files/35m.jpg?v=1710991308)
Figure 35
The two halfs of the mold are joined and held together using mold straps.